Foxconn 925XE7AA-8EKRS2-RAID - Manual (Page 31)

RAID User’s Guide
29
SECTION1
SECTION3
SECTION2
This window has three main sections:
SECTION 1: System listing of all formatted and available disks/RAID Sets.
SECTION 2: Report of physical connection of disks/RAID Sets.
SECTION 3: Report of partition status, disk letter, and volume name.
Initial Window
In SECTION 2, every disk should report as:
Basic
Disk Size (the actual available disk space will be reported here)
Online
Instead of “Basic”, a disk may also report as either “Unknown” or “Dynamic”.
If the disk reports as “Unknown”, right-click on the disk icon (SECTION 2) and
click on Write Signature.
At this point, a window will appear with the disk in question (all “Unknown” disks
may appear in this window).Make sure the box next to each disk is checked, then
click OK. The disk should now report as “Basic”.
If a disk reports as “Dynamic”, right-click on SECTION 2 of that disk, and click on
“Return disk to Basic...” Within seconds the disk should report as Basic.
ＲＡＩＤ Ｍａｎｕａｌ．ｐ６５ 2005-1-21, 10:29 29