FSR ML-116 - Manual (Page 15)

FSR
ML-116 INSTALLATION DATA
Telephone 973-785-4347 page 15
The interconnect cable from the ML-116 ACU to the Monitor panel is the same wire used to connect
the wallplates. The cable from the Monitor panel to the Monitor relay card is supplied with the
system.
partial view of the
CPU module
(located in the ACU)
connect to any
one of these 4
terminal blocks
rear of the Monitor/VU Panel
Monitor relay card
rooms one thru sixteen
Not used in this application
Monitor/VU hookup diagram
EXT 1 (aux amp A)
EXT 2 (aux amp B)
from room 16's amplifier output
from room 1's amplifier output
an 8' ribbon cable (14 conductors) is supplied (MNRL-CBL)
this card requires that all amplifiers
have a 70 volt speaker drive