FSR ML-116 - Manual (Page 6)

page 6 Telephone 973-785-4347
FSR
ML-116 INSTALLATION DATA
UNPACKING
Your ML-116 system should contain the following components;
• ACU (audio control unit) This is the large unit and may have the map panel, if
ordered, on the front.
• ML-PSA ( large power supply)
• Wall Plates Room control panels, one for each room in the system. Depending on the
order either 2 or 3 gang wallplates will be shipped. On some installations two
wallplates may be required per room.
• If head tables were ordered you should have an HTBC card, 1-4 HT-8 cards, power supply,
and one or two 19 inch TRAC-BRACs depending on the number of HT-8
cards. Each HT-8 card will handle up to 8 Head Table locations.
• If the Monitor/VU panel was ordered you should have the Monitor Panel and ribbon
connecting cable along with the Monitor Relay Card mounted on a 19 inch
TRAC-BRAC.
• If the Facility Manager Panel was ordered you should have an FM-INT Interface Unit, the
RS-232 interconnect cable, a 3.5" diskette, and a power supply. (*)
• If the Remote Audio feed was ordered you should have an enclosed audio speaker along
with special relay cards (116-MNRL and 116-MNP) mounted on a 19 inch
TRAC-BRAC. (*)
• If the Remote Map Panel was ordered you should have the R-MAP Panel with its power
supply.
• If the Remote Monitor Panel was ordered you should have the R-MON Panel which will
mount on top of the R-MAP Panel.
• If the Lutron lighting interface was ordered then you should have the ML-116-INT & power
supply unit.
• An installation Manual.
• A users Manual.
(*) With multiple ML-116 systems with the FMP or AUX option(s) some duplicate compo
nents are not provided