GAI-Tronics 293-101 Externally Powered ADA-Compliant Emergency Phones - Manual (Page 21)

Pub. 42004-378C
E XTERNALLY P OWERED ADA-C OMPLIANT E MERGENCY P HONES P AGE 20 of 28
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-378c.doc
08/06
Password
The Password Protection feature allows you to change the four-digit password required to remotely
program the emergency telephone. Each telephone is password protected to maintain the integrity of
programmed information and should not be disabled.
The password is required to enter the programming mode when programming the telephone from a
remote location. The programming password hardware configuration must be enabled when
programming with the password. To enable the Password Protection feature, insert the J9 jumper on pins
2 and 3. Complete the key sequence to change the four-digit password.
Feature Key
Sequence
Description
Default
Password
Protection # 1 4 N N N N A four-digit password must be supplied to remotely program
the telephone. If you change the password and cannot enter
programming mode, see the Password Disabled Programming
section.
Example: To program the password 1234, enter # 1 4 1 2 3 4.
2468
Silent Monitoring Feature
When the Silent Monitoring feature is enabled, individuals near the telephone will not be able to hear the
person who is monitoring the area.
Feature Key
Sequence
Description
Default
Silent
Monitoring # 1 6 L Enabling the Silent Monitoring feature allows a person to call the
emergency telephone and monitor the area around the telephone
with the emergency telephone’s speaker muted.
To enable the Silent Monitoring feature, L=1.
To disable the Silent Monitoring feature, L=0.
0
(Disabled)
Off-Hook Ringing
The emergency phone can generate a ringing signal from the speaker when the phone is called. As a
factory default, this feature is disabled.
Feature Key
Sequence
Description
Default
Ringing # 2 2 L Enabling the Off-Hook Ringing feature allows a person to call the
phone and have the phone function as a normal telephone. The
phone will ring after the splash tone is heard in the receiver if
remote programming is not commenced within 7 seconds of the
splash tone.
To enable the ringing feature (enable splash tone and ringing), L=1.
To disable the ringing feature (only splash tone on the phone), L=0
N OTE : Only Model 294AL-101 and 298-101 Phones can be
answered when they are ringing by pressing the Call button.
0
(Disabled)