GAI-Tronics 397-700CB RED ALERT VoIP Retro-fit Telephones - Manual (Page 11)

P UB . 42004-461D
H ANDS - FREE V O IP R ETRO -F IT T ELEPHONES P AGE
11 of 23
f:\standard ioms - current release\42004 instr. manuals\42004-461d.doc
02/15
Removal and Replacement Installation (All Models)
The appropriate RED ALERT ® retrofit models are designed to replace Code Blue, Ramtel, or Talk-A-
Phone telephones utilizing a six-hole mounting pattern, as follows:
1. Remove the existing telephone.
2. Remove the retro-fit telephone’s back box from its front cover. Retain the hardware for re-
installation.
3. Remove the plug from the opening being used on the back box and feed the Ethernet line and
peripheral device wiring through the cable entry hole.
4. The connecting line should be equipped with an RJ45 modular connector. Plug the connector into the
mating network connector on the VoIP PCBA mounted to the Carrier PCBA. Refer to Figure 9.
5. Connect any required peripheral devices. Refer to Figure 9 and Figure 10.
6. Re-attach the back box to its front panel.
7. Allow the telephone a minimum of 35 seconds to initialize.
8. Using the “Setup” section of this manual, perform the initial programming. Refer to the
“Programming” section on page 19.
9. Verify operation by calling to and from another phone. Verify operation of peripheral equipment.
10. Complete the installation by attaching the RED ALERT ® Retro-fit VoIP Telephone in place of the
removed telephone using the security screws provided, 10–12 in-lbs. of torque recommended.