GAI-Tronics XAAB002A Audio Accessory Box - Manual (Page 18)

Installation Model XAAB002A Audio Accessory Box
11/06 14
Mechanical Receipt Inspection
The XAAB002A Audio Accessory Box is shipped in a cardboard container with inserts. Thoroughly
inspect it as soon as possible after delivery. In-transit damage should be immediately reported to the
transportation company.
Mounting
The Audio Accessory Box can sit on a desktop or can be mounted to the side or under the desk by means of
mounting screws through the top cover piece. In this case, the chassis bottom piece is rotated 180
° and
secured upside down into the cover after the cover has been mounted under the desk or tabletop.
Equipment Required
Test Equipment
• RF service monitor
• #1 Phillips screwdriver
• 1/8-inch flat blade screwdriver
Documentation
• instruction manuals from optional accessories
• these installation instructions
Cable Installation Safety Considerations
Interconnecting, communications, and Class 2 dc power cables should be separated from electrical light or
other Class I circuits by at least 2 inches. The exception is where Class I wiring or power circuits are run
in a raceway, or are metal-sheathed or metal-clad, or are permanently separated from the conductors of the
other circuitry by a continuous and firmly fixed nonconductor such as porcelain tubes or flexible tubing in
addition to the insulation on the wire. Communications cables and in-building wiring should be listed and
marked for the purpose according to NEC Article 800.