GAI-Tronics 12514-007, 12514-008, 12514-009 6', 15', 25' Coil Cord, 6C and Bushing Kit - Manual (Page 3)

Pub. 42003-035B
M ODELS 12514-007, 12514-008, AND 12514-009 PVC C OIL C ORD R EPLACEMENT K IT Page: 3 of 6
\\s_eng\gtcproddocs\standard ioms - current release\42003 kit manuals\42003-035b.doc
5. Press the bushing tight against the front panel, and insert the C-clip on the rear of the bushing on the
back side of the front panel assembly, or use a Heyco® bushing tool to squeeze the Heyco® bushing
back into the front panel opening.
6. Reconnect the four telephone wires to the PC board in this manner: red to E1; green to E2; white to
E3; black to E4.
7. Reconnect the modular telephone wire to the RJ11 jack on the PC board and fasten the front panel
assembly to the rear enclosure.
Models 701-201, 701-202, 701-203, 701-204, and 701-205
Removal of old cord
1. Unscrew the four front panel screws and remove the handset amplifier from the enclosure.
2. Unscrew the handset transmitter cap and lift out the transmitter.
3. Disconnect the wires from the transmitter.
4. Unscrew the receiver cap. Lift out the receiver.
5. Disconnect the red and green wires from the handset PC board. For stations with a pressbar handset,
proceed to Step 6. For stations without a pressbar handset, proceed to Step 8.
6. Loosen the two screws securing the pressbar. Lift off the metal retainer, plastic pressbar, curved
spring and plunger.
7. Lift out the rectangular plastic cup and disconnect the blue and yellow wires.
8. Pull the old cord out of the handset. Place the amplifier to easily access the rear of the unit.
9. Loosen the four screws securing the backbox to the amplifier. The backbox will still be connected to
the amplifier. Carefully separate a the two pieces.
10. Disconnect the yellow (E5), blue (E6), red (E4), white (E1), black (E2) and green (E3) wires from the
PC board. Stations without pressbar handsets will not have the blue and yellow wires.
11. Using a Heyco® bushing tool or needlenose pliers, pull the bushing and the cord through the front
panel and discard.