GAI-Tronics 12613-001 Keypad Seal Kit for 246C, 256C, 246-001 and 256-001 - Manual

Pub. 42003-230A
GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
Keypad Seal Kit
for 246C, 256C, 246-001 & 256-001 Phones
Model 12613-001
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.
General Information
The Model 12613-001 Keypad Seal Door Kit is for use on the GAI-Tronics Model 246C, 256C, 246-001
and 256-001 Industrial Phones. This kit includes the following components:
Item Qty. Description
A 1 Keypad mounting panel assembly
B 8 PPHTF screws #4
× ¼-inch
C 1 Keypad seal
D 1 Keypad spacer plate
E 2 .062-inch flat nylon washer
Installation
Unpack the material and compare the included parts to the list above to ensure that all parts are present.
N
OTE : Large and small tip Phillips head screw drivers and ¼-inch nut driver are required for installation
of this kit.
Disassembly
1. Unscrew front panel of phone from enclosure/back box and carefully disconnect the field wiring.
Please make note of all field wiring connections.
2. See Figure 1. The printed circuit board assembly (PCBA) is mounted with six screws. Four screws
mount to the keypad mounting panel below and two mount to standoffs on the phone front panel.
Remove the two 4-40
× ¼-inch screws from the hex standoffs and save for reassembly later.
Unscrew the other four screws about ¼ inch or until they disengage from the keypad mounting panel
below. (These screws will also be reused when re-assembly later.)