Geist Upgradeable PDU - Manual (Page 37)

Web Interface 37
© 2015 Geist GM1157 - GU PDU Instruction Manual
To send a test e-mail:
1. Click on the Test Email icon next to the address you wish to test.
2. A pop-up window will indicate that the test e-mail is being sent. Click OK to
dismiss the pop-up.
4.2.4 SNMP
Simple Network Management Protocol (SNMP) can be used to monitor the unit's
measurements and status, if desired. SNMP v1, v2c and v3 are supported. In
addition, alarm traps can be sent to up to two IP addresses.
The SNMP Service can be enabled or disabled, as desired. The service will normally
listen for data-read requests (a.k.a. "Get requests") on Port 161, which is the usual
default for SNMP services; this can also be changed if desired.
The MIB is can be downloaded from the unit, if needed, via the MIB link at the top of
the web page. Clicking this link will download a .ZIP archive containing both the MIB
file itself, and a CSV-formatted spreadsheet describing the available OIDs in a human-
readable form to assist you in setting up your SNMP manager to read data from the
unit.