D-Link DFL-500 - Manual (Page 14)

DFL-500 User Manual
14
Data bits 8
Parity None
Stop bits 1
Flow control None
• Press Enter to connect to the DFL-500 CLI.
The following prompt appears:
DFL-500 login:
• Type admin and press Enter.
The following prompt appears:
Type ? for a list of commands.
For information on how to use the CLI, see the DFL-500 CLI Reference Guide .
Next steps
Now that your DFL-500 NPG is up and running, you can proceed to configure it for operation:
• If you are going to run your DFL-500 NPG in NAT/Route mode, go to
NAT/Route mode installation .
• If you are going to run your DFL-500 NPG in Transparent mode, go to
Transparent mode installation .