D-Link DFL-500 - Manual (Page 88)

DFL-500 User Manual
88
Configuring the internal interface
To configure the internal interface:
• Go to System > Network > Interface .
• For the internal interface, select Modify .
• Change the IP address and Netmask as required.
• Select the management Access methods for the internal interface.
HTTPS To allow secure HTTPS connections to the web-based manager through the internal interface.
PING
If you want the internal interface to respond to pings. Use this setting to verify your installation and for
testing.
SSH To allow secure SSH connections to the CLI through the internal interface.
SNMP
To allow a remote SNMP manager to request SNMP information by connecting to the internal interface.
See
Configuring SNMP .
• Select OK to save your changes.
If you changed the IP address of the internal interface and you are connecting to the internal interface to
manage the DFL-500 NPG, you must reconnect to the web-based manager using the new internal interface
IP address.
Configuring the internal interface
Configuring the external interface
Use the following procedures to configure the external interface:
•
Configuring the external interface with a static IP address
•
Configuring the external interface for DHCP
•
Configuring the external interface for PPPoE