Hypertherm HD3070 w/ Automatic Gas - Manual (Page 13)

1-10 HD3070 w/Automatic Gas Console
5 SPECIFY THE WORK CABLE BETWEEN THE POWER SUPPLY AND THE
WORK TABLE
The work (positive) cable connects the positive side of the power supply circuit to the
workpiece via the cutting (work) table. It should be kept as short as possible.
• Determine the necessary length for the work cable and order from the parts list on page 1-11.
6 SPECIFY THE LEADS BETWEEN THE POWER SUPPLY AND THE GAS
CONSOLE
The automatic gas console normally mounts on the power supply and uses two (2) six-foot
(2 m) cables to interface to the power supply. If the power supply will be placed farther than
40 feet from the torch off-valve assembly, the gas console will have to be mounted closer to
the torch and may require cables greater than six feet to interface with the power supply.
• Determine where the gas console will be mounted and the distance between the power
supply and the gas console. Order the appropriate length leads.
Note that the hoses from the gas supplies to the gas console are not provided by
Hypertherm.