Hypertherm HD3070 w/ Automatic Gas - Manual (Page 15)

1-12 HD3070 w/Automatic Gas Console
SPECIFY THE TORCH CONFIGURATION
The torches for the HD3070 system are the PAC184 and PAC186. Hypertherm does not provide
a torch mounting bracket for the torches. Precision and robotic cutting machines have their own
mounting brackets that have proven to be adequate for the PAC184 and PAC186 torches. A
variety of torch configurations are available due to the interchangeability of the torch head, quick
disconnect assemblies and torch mounting sleeves.
• Determine the type of torch, quick disconnect and mounting sleeve you need, and specify using
the figure on page 1-13 and the following brief descriptions as guides:
7 PAC186 Torch
This torch head comes loaded with 15-amp consumables and is more commonly used with an
X-Y table. The PAC186 is capable of cutting with up to 100 amps of current. There are two
varieties: one torch includes a retaining cap with a tab for an initial height sensing (IHS) system
and the other torch comes without the tab. Determine if the system will be including a THC
system before ordering (Hypertherm offers a Command THC system for the HD3070).
7a PAC186 Consumable Parts Kits (not shown on page 1-13)
Order one of these consumable parts kits if you specify either of the PAC186 torches. One kit
contains an extra torch body, and the other does not. Both kits include consumables for cutting
with 15, 30, 50, 70 or 100 amps.
8 Quick Disconnect Assembly - Straight
Can be used with either torch. More commonly used with the PAC186.
9 10 Inch Mounting Sleeve
Can be used with either torch depending on cutting machine's torch mounting design.
10 PAC184 Torch
This torch head comes loaded with 30-amp consumables and is more commonly used in robotic
applications. The PAC184 is capable of cutting with 15 or 30 amps of current. There are two
varieties: one torch includes a retaining cap with a tab for an initial height sensing (IHS) system
and the other torch comes without the tab. Determine if the system will be including a THC
system before ordering (Hypertherm offers a Command THC system for the HD3070).
10a PAC184 Consumable Parts Kits (not shown on page 1-13)
Order one of these consumable parts kits if you specify the PAC184 torch. One kit contains an
extra torch body, and the other does not. Both kits include consumables for cutting with 15 or 30
amps.
11 Quick Disconnect Assembly - 45
°
Can be used with either torch. More commonly used with the PAC184.
12 8 Inch Mounting Sleeve
Can be used with either torch depending on cutting machine's torch mounting design.
4-98