Hypertherm HD3070 w/ Automatic Gas User Manual
Page 9
1-6
HD3070 w/Automatic Gas Console
1
HD3070 Power Supply, Auto
2
HD3070 Automatic Gas Console
3
Remote High Frequency (RHF) Console
4
15 Ft Leads Between Power Supply and RHF Console
5
39.4 Ft Work Cable Between Power Supply and Work Table
6
6 Ft Leads Between Power Supply and Auto Gas Console
7
PAC184 Machine Torch Assy
8
PAC184 Machine Torch Quick Disconnect Assembly and Leads:
8a PAC184 45
°
Quick Disconnect
8b 8 Inch Torch Mounting Sleeve
8c Off-Valve Assy (Off-Valve comes with or without Blow Down Solenoid Valve)
8d 4 Ft Hoses from Off-Valve Assy to Torch
8e 35 Ft Leads from Gas Console to Off-Valve Assy
8f
19.7 Ft Leads from RHF Console to Torch (Leads come with or without Blow Down
Check Valve & Hose)
9
28.2 Ft Cable Between Gas Console and Cutting Machine Interface
10 28.2 Ft Control Cable Between Power Supply and Cutting Machine Interface
11 28.2 Ft Current Setpoint Cable Between Power Supply and Cutting Machine Interface
12 28.2 Ft Timer-Counter Cable Between Power Supply and Cutting Machine Interface
If this exact configuration will work for your particular site, simply order by using the
appropriate system number listed directly below.
078067
HD3070 Plasma System w/Auto Gas Console, 200V, 50/60 Hz, 3Ø
078068
HD3070 Plasma System w/Auto Gas Console, 208V, 60 Hz, 3Ø
078069
HD3070 Plasma System w/Auto Gas Console, 220/380/415V, 50/60 Hz, 3Ø
078070
HD3070 Plasma System w/Auto Gas Console, 240/480V, 60 Hz, 3Ø
078071
HD3070 Plasma System w/Auto Gas Console, 600V, 60 Hz, 3Ø
To customize a system, begin on page 1-8 and use the order form.
SINGLE-SYSTEM ORDERING PROCEDURE
SYSTEM ORDERING FOR HD3070 w/AUTOMATIC GAS CONSOLE -
ROBOTIC APPLICATIONS
Special numbers have been established for ordering an entire HD3070 system. Under these
numbers, all cables, hoses and leads are at fixed lengths. Refer to the list below and Figure
1-3 on the following page for clarification of the system.
1-00