Hypertherm HySpeed HT2000 Plasma Arc Cutting System Rev.7 - Manual (Page 27)

ORDERING PROCEDURE
2-8 HySpeed HT2000 Product Configuration Manual
6
can best be attached.
Specify the Leads Between the Power Supply and the Remote High Frequency
Console
The lead package between the power supply and the remote high frequency console consists of one
negative lead (4/0 cable), one pilot arc lead, one control cable, and two coolant hoses.
• Based on the distance (the path that the leads will have to run) between the power supply and the remote
high frequency console, order the appropriate lead package.
Specify the Shielded Leads Between the Torch and the Remote High Frequency
Console
The shielded lead package between the remote high frequency console and the torch consists of two
torch coolant hoses, one pilot arc lead and one cap-sensor hose. This lead package is bound together by
an external sheathing. If the leads are being placed in a power track, then measure the length from torch
through the power track to the console and allow about 3-5 feet of extra length. If a festoon system is
used, measure the width of the bridge and double it for lead length.
• Based on the distance between the torch and the remote high frequency console and the above
considerations, order the appropriate lead package.
Specify the Gas Console
This unit houses metering and solenoid valves for shield and plasma gases, flowmeters and pressure
gauges for nitrogen and oxygen plasma, and a pressure gauge for the shield gas supply. The gas console
interfaces with the plasma and shield gas supplies, the RHF console, the motor valve console and the
power supply. Fabrication of a mounting bracket may be necessary.
• The gas console should be mounted in a convenient location for the operator – usually next to the cutting
machine controller. Determine approximately where the console will be mounted in relation to the operator,
power supply, gas supplies, motor valve console, remote high frequency console, and the torch. Check
mounting holes and weight and order the gas console.
6
5
4