Hypertherm HySpeed HT2000 Plasma Arc Cutting System Rev.7 - Manual (Page 39)

ORDERING PROCEDURE
2-20 HySpeed HT2000 Product Configuration Manual
7
Specify the Hose Between Gas Supplies and Gas Console (continued)
• Order nitrogen plasma gas hose.
• Order shield gas hose.
Specify the Argon/Hydrogen Console
This unit houses a flowmeter for argon/hydrogen, a metering valve, a pressure switch, and a plasma-off
valve. The argon/hydrogen console interfaces with the power supply, the argon/hydrogen supply gas, and
the torch.
Note: The argon/hydrogen console must be mounted within 40 feet (12 m) of the torch. Fabrication of
mounting brackets may be necessary.
• Determine where the argon/hydrogen console will be mounted and order the console.
Specify the Cable Between the Argon/Hydrogen Console and the Power Supply
This unit houses a flowmeter for argon/hydrogen, a metering valve, a pressure switch, and a plasma-off
valve. The argon/hydrogen console interfaces with the power supply, the argon/hydrogen supply gas, and
the torch.
• Based on the distance (the path the leads will take) between the argon/hydrogen console and the power
supply, specify the appropriate part number.
Specify the Hose Between the Argon/Hydrogen Console and the Torch
This hosing connects to the off valve which is attached to the torch.
• Order the argon/hydrogen hose.
Spare Parts Kit
The spare parts kit provides an initial supply of consumables, O-rings, tools and silicone grease. One spare parts
kit should be ordered with each system. Part number 028602 has standard consumables. Part number 128825 has
HySpeed consumables.
26
25
24
23 c
23 b
23