Hypertherm HySpeed HT2000 Plasma Arc Cutting System Rev.7 - Manual (Page 35)

ORDERING PROCEDURE
2-16 HySpeed HT2000 Product Configuration Manual
6
Ordering Procedure – Optional and Additional Equipment
Specify the Hold Cable
If the application is to use a two-torch system, a hold cable is required to interface the power supplies.
• Determine where the additional power supply is to be positioned, and order the appropriate hold cable
from the parts list on page 2-17.
Specify the Inductive Initial Height Sensing (IHS) System
This unit, consisting of a control box with two inductive probes, is designed to automatically detect the
workpiece surface and index the torch to the pierce position. This system can be used for underwater, at
the water line, or above-water applications. This unit interconnects with the power supply through the IHS
lead set and the inductive probes, and requires an air supply to operate.
The IHS console must be located within 40 feet of the torch. See Figure 1-5 on pg. 1-9 for weight and
mounting requirements.
• There are 2 IHS systems to choose from. One is used with the 2" (50 mm) diameter torch and the other is
used with the 1-3/4" (44 mm) diameter torch. Order the IHS system to match the same diameter torch
ordered in step 2. The IHS number includes the IHS console, torch mounting bracket, air cylinder and
inductive sensor assemblies.
Note: The torch mounting bracket from step 2a is not needed when the IHS is ordered.
Specify the IHS Pressure Regulator Assembly
• Order the pressure regulator assembly. This number includes air regulator and regulator mounting bracket.
See Figure 1-6 on pg. 1-10 for IHS air regulator mounting bracket dimensions.
Specify the Inductive IHS Lead Set
• Order the IHS lead set. The lead set consists of two 40-foot sensor probe cables, a 50-foot air cylinder
hose, and a control cable that is connected to the power supply. Based on the distance between the power
supply and the IHS console, select the appropriate number from the parts list on page 2-17.
19
18 a
18
17