Hypertherm HySpeed HT2000 Plasma Arc Cutting System Rev.7 - Manual (Page 7)

SPECIFICATIONS
1-2 HySpeed HT2000 Product Configuration Manual
7
System Requirements
Power Requirements:
Refer to power supply specifications below:
Gas Requirements:
Plasma Gas Types ..............................................Oxygen (O
2
), Nitrogen (N
2
), Air,
Argon/Hydrogen (H35 = 35% Hydrogen/65% Argon)
Shield Gas Types .................................................Air, Nitrogen (N
2
), Carbon Dioxide (CO
2
)
Gas Quality
Oxygen .............................................................99.5% pure (liquid gas recommended)
Nitrogen............................................................99.995% pure (liquid gas recommended)
Air .....................................................................Clean, dry, oil-free
Carbon Dioxide ................................................99.5% pure (liquid gas recommended)
Plasma Gas Inlet Pressures and Flowrates
Air .....................................................................90 psi (6.2 bar) at 82 scfh (2322 l/h)
Oxygen .............................................................120 psi (8.3 bar) at 90 scfh (2549 l/h)
Nitrogen............................................................120 psi (8.3 bar) at 80 scfh (2265 l/h)
Argon/Hydrogen ...............................................120 psi (8.3 bar) at 105 scfh (2973 l/h)
Shield Gas Inlet Pressures and Flowrates
Air .....................................................................90 psi (6.2 bar) at 280 scfh (7929 l/h)
Carbon Dioxide ................................................90 psi (6.2 bar) at 220 scfh (6230 l/h)
Nitrogen............................................................90 psi (6.2 bar) at 275 scfh (7787 l/h)
Power Supply
Dimensions and Weight
Width ....................................................................28-1/4" (71 cm)
Height ...................................................................35-1/2" (90 cm)
Depth....................................................................41-1/4" (104 cm)
Weight ..................................................................780 pounds (351 kg)
Torch Assembly
Dimensions and Weight:
Length with sleeve: ..............................................17-3/4" (45 cm)
Sleeve Diameter...................................................2" (50 mm) std&stnlss.; 1-3/4" (44 mm) optional torch
Weight ..................................................................2-1/2 pounds (1.13 kg)
Lead Lead Diameter (O.D.) Connector/Lug Diameter
Off valve Plasma Hose 3/8" (9.5 mm) 3/8" (9.5 mm)
Off valve Control Cable 1/4" (6 mm) 3/4" (19 mm)
2
1
System Specifications and Dimensions – Required Equipment