IBASE MB945 User Manual
Page 40
BIOS SETUP
36
MB945 User’s Manual
Security Option
This field allows you to limit access to the System and Setup. The default
value is Setup. When you select System, the system prompts for the User
Password every time you boot up. When you select Setup, the system
always boots up and prompts for the Supervisor Password only when the
Setup utility is called up.
APIC Mode
APIC stands for Advanced Programmable Interrupt Controller. The
default setting is Enabled.
MPS Version Control for OS
This option is specifies the MPS (Multiprocessor Specification) version
for the OS. MPS version 1.4 added extended configuration tables to
improve support for multiple PCI bus configurations and improve future
expandability. The default setting is 1.4.
OS Select for DRAM > 64MB
This option allows the system to access greater than 64MB of DRAM
memory when used with OS/2 that depends on certain BIOS calls to
access memory. The default setting is Non-OS/2.
Small Logo (EPA) Show
The EPA logo appears at the right side of the monitor screen when the
system is boot up. The default setting is Disabled.
Console Redirection
This configuration is supported only with MB945AF (with iAMT
function). The default setting is Disabled.
Baud Rate
This configuration is supported only with MB945AF (with iAMT
function). The default setting is 19200.
Agent after boot
This configuration is supported only with MB945AF (with iAMT
function). The default setting is Enabled.