IBEA IBT-3000 Series - Manual (Page 27)

Minitransporter IBT-3000 Pag. 27
HOW TO STOP
1. Put the throttle lever on low speed (fig. 3).
2. Release the traction lever slowly (fig. 9).
The body of the unit can lift off the ground on a steep slope when slowing speed.
Please exercise precaution against this possibility.
3. To stop the unit just turn the switch to “OFF” position (fig. 4).
4. Finally, close the fuel cock (fig. 2).
Never leave the unit in a place where untrained people could start it.
Store the machine in an attended place and disconnect the spark plug wire to avoid accidental
starting.
MANUAL DUMPING OPERATION
(Lifting)
Push the dump lever down.
This will release the bed lock and raise the bed (fig. 10).
(Lowering)
When the bed is lowered, the locking mechanism operates, locking the bed. To check that the bed is se-
curely locked, try to lift it without pulling up the dump lever.
Please be aware that if the bed lock is released on a steep slope when a load is concentrated
in the front of the bed, the load can suddenly dump itself. For safety reasons, always drive
the machine to a level surface before dumping the bed content.
EXTENSIBLE BED
The loading bed of your unit is equipped with extendible side panels which will allow you to match the bed
dimensions with your transport need.
The side panels are individually extendible.
Just loosen the stop knobs on the lower side of the bed and extract the panels as necessary.
The side panels can be extended to a maximum of 150 mm. This figure is measured from the bed to the
panel (fig. 12).
Note: For safety reasons, do not exceed this value.
Make sure you tighten the side panel knobs correctly and secure the load applied.
In order to balance the load applied, it is always advisable to maintain the same left and right panel over-
hang, so turning over of machine can be avoided.
IBT3000_2014_P5090604.indd 27 27/10/14 16.21