Infloor Crimp Fittings User Manual
Page 2
~ 1 ~
Introduction
Infloor carries a complete line of crimp fittings for PEX and PAP tubing. This document covers the differences
between the different methods, the tools and the various parts Infloor carries for this type of fitting.
Crimp Fittings
There are three different types of crimp fittings that are available; two for PEX tubing and another set for PAP
fittings. A summary of which crimp ring goes with which crimp tool is shown below:
Crimp Rings
Part
Number
Size
Crimp Tool
Part Number
24000
3/8”
26020
24001
1/2”
26021
24002
3/4”
26022
24003
1”
26023
If you are working with PEX, there is basically no difference between using the crimp rings and clamp rings in
terms of performance of the joint. Crimp rings are slightly cheaper, but require a different tool for each size,
where as the clamp rings are a little more, but require a single tool. Both systems use the same barb fitting.
Many different fittings are available to adapt PEX to a pipe thread, sweat, or to another
section of PEX. The fittings have a common barb on them for different sizes of PEX. Be
sure to order the fitting for the size PEX you are using, as the barbs are not interchangeable
between different sizes of PEX. A summary of the different fittings offered by Infloor and
their part numbers are shown on the following page.
Clamp Rings
Part
Number
Size
Clamp Tool
Part Number
24005
3/8”
26025
24006
1/2”
24009
5/8”
24007
3/4”
24008
1”
PAP Crimp Fittings
PAP crimp rings come with the
fittings. A crimp tool is required
along with a set of jaws that are
sized for crimping the ring.
Part
Number
Size
Crimp Tool
Part Number
24540
1/2”
24538
24542
3/4”
24543
1”
PAP Crimp Fittings
A smaller tool is offered for 1/2”
PAP only.
Part
Number
Size
Crimp Tool
Part Number
24536
1/2”
24535