Ivoclar Vivadent Telio CS - Manual (Page 16)

Shaping of temporaries
a) Fabrication in the mouth
The prepared teeth should be slightly moist. This can be achieved by painting them with water-soluble
glycerine gel (e.g. Liquid Strip). Undercut areas of the tooth preparation or adjacent teeth may have to be
blocked out with appropriate materials (e.g. with kneadable rope wax).
Carefully reposition the impression filled with Telio CS C&B on the prepared teeth. The setting time is
approx. 1 to 2 minutes at a temperature of 37 °C / 98 °F. At room temperature (23 °C / 73 °F), e.g. when
the restoration is fabricated on a model, the material takes longer to cure (approx. 3 minutes).
When the material is nearly cured (hard-elastic, partially cured state) the impression can be removed from
the patient’s oral cavity. Remove the unfinished Telio CS C&B temporary from the impression using a spa-
tula (e.g. OptraSculpt).
16
Reposition the filled impression on the prepared teeth. The setting time in the mouth is approx. 1-2 minutes.
Removing the impression Removed impression with non-finished Telio CS C&B restoration
Remove the unfinished Telio CS C&B temporary from the impression using a spatula.