Ivoclar Vivadent Telio CS - Manual (Page 6)

Composition
• Telio CS C&B
Components: Polyfunctional methacrylates
(48 wt.%), inorganic fillers (47 wt.%),
additives, initiators, stabilizers and pigments
(5 wt.%).
• Telio CS Desensitizer
Components: Polyethylene glycol dimeth-
acrylate and glutaraldehyde in an aqueous
solution.
• Telio CS Link
Components: Bismethacrylates (56 wt.%),
fillers (43 wt.%), initiators, stabilizers,
pigments.
• Telio CAD Blocks
Components: Polymethyl methacrylate
(PMMA), pigments.
• Telio Stains
Components: Bis-GMA, urethane dimeth-
acrylate and triethylene glycol dimethacrylate
(86 wt.%), fillers and pigments (13 wt.%),
catalysts, stabilizers.
• Telio Add-On Flow
Bis-GMA, urethane dimethacrylate and
decandiol dimethacrylate (40.5 wt.%), fillers
(59 wt.%), catalysts, stabilizers and pigments
(0.5 wt.%).
• Telio Activator
Components: Methyl methacrylate (86-87%),
dimethacrylate (13%) and catalyst (<1%).
6
Prevention of premature loss of retention:
Apart from a retentive preparation design, the
reliable cementation of Telio CAD restorations
using a temporary luting material (e.g. Telio CS
Link) depends on the accuracy of fit, which is
determined by the CAD/CAM system used.
Important processing restrictions
If the following restrictions are not observed,
successful working with the Telio materials cannot
be ensured:
• Telio CS C&B and Telio CAD must not be used
to fabricate final restorations.
• Telio CS Link must not be used for the
permanent cementation of restorations.
• The Telio material should not be used if a
patient is known to be allergic to any of its
ingredients.
• The required minimum thicknesses must be
observed.
• Staining/layering of Telio CAD using materials
that are not approved and/or recommended.
• Milling the Telio CAD blocks in a non-
compatible/non-authorized CAD/CAM system.
• Do not inhale grinding dust during finishing.
Use exhaust air discharge and dust mask.