Ivoclar Vivadent IPS e.max CAD Chairside - Manual (Page 30)

30
Extrude IPS e.max CAD Crystall./Shades and Stains from the syringe and mix thoroughly. If
required, thin with IPS e.max CAD Crystall./Glaze Liquid Apply mixed Shades and Stains directly on the blue restoration.
Option A:
Crystallization and Stain/Glaze firing in one step with IPS e.max CAD Crystall./Glaze Spray
The spray should only be used for restorations which allow IPS Object Fix auxiliary firing paste to be adapted exactly to the
margins.
Please observe the following procedure:
– If characterizations are desired, the restoration can be individualized using IPS e.max CAD Crystall./Shades and IPS e.max
CAD Crystall./Stains before Crystallization firing.
– Extrude Shades and Stains from the syringe and mix thoroughly.
– The ready-to-use Shades and Stains may be slightly thinned using IPS e.max CAD Crystall./Glaze Liquid. However, the
consistency should still remain pasty.
– Hold the restoration by the IPS e.max CAD Crystallization Pin.
– Apply mixed Shades and Stains directly on the blue restoration using a brush.
– Observe the Characterization guide (see page 28) for applying Shades and Stains.
Please observe the following procedure for the application of the IPS e.max CAD Crystall./Glaze Spray:
– Hold the restoration by the IPS e.max CAD Crystallization Pin. Do not spray the restoration on the
IPS e.max CAD Crystallization Tray, as it would also be coated with glaze.
– Shake the Glaze Spray well immediately before use until the mixing ball in the container is moving freely
(approximately 20 seconds). If the spray is not sufficiently shaken, mainly the propellant is discharged
with a spraying burst. This, in turn, results in insufficient application of the Glaze Spray.
– Observe a distance of approx. 10 cm between the nozzle and the surface to be sprayed.
– Hold the spray can as upright as possible during spraying.
– Spray the restoration from all sides with short bursts while simultaneously rotating the restoration so
that an even, covering layer is created. Shake the spray can again between individual bursts.
– Spray the restoration a second time from all sides with short bursts while simultaneously rotating the
restoration so that an even, covering layer is created. Shake the spray can again between individual
bursts.
– Wait briefly until the glaze layer is dry and has assumed a whitish colour.
– Areas that do not show an even layer have to be sprayed again.
– Place the restoration in the center of the IPS e.max CAD Crystallization Tray.