Kemppi Protig 410 - Manual (Page 10)

EN
20 Earth cable
21 MMA welding cable
22b Mig gun liquid-cooled
23b TIG torch, liquid-cooled
23d TIG extension cable, liquid-cooled
2. INSTALLATION
2.1 ASSEMBLY OF TIG/MMA EQUIPMENT
Assemble the equipment in below-mentioned order and follow mounting and operation
instructions which are delivered with packages.
2.1.1 Installation of power source
NOTE! Connection of mains cable and mounting operations as well as change of plug should only
be carried out by a competent electrician.
Read paragraph: ”Installation” in operation instructions (1913130) for Pro power sources and
carry out the installation according to that.
2.1.2 Assembly of transport wagon and mounting of Pro power source to wagon
P20 6185261 air-cooled TIG equipment
P30W 6185262 liquid-cooled TIG equipment
P40, P40L 6185264, 6185264L air-cooled TIG equipment
Lifting of wagon together with bottle is forbidden due to safety reasons!
2.1.3 Mounting of Protig 410 unit onto the power source (figure page 5)
NOTE! Lock the Protig unit carefully as shown in fig. onto pro power source. Loose unit might cause
a danger situation.
2.1.4 Mounting of Protig 410 control panel
TL 6271265
TX 6271266
2.1.5 Connecting cables
Follow enclosed figures:
Air-cooled equipment on page 5
Liquid-cooled equipment on page 6
When connecting cables take into consideration the fact that the most generally used polarity
in TIG welding is the torch - and ground cable +. In MMA welding the polarity is generally
on the contrary (Electrode holder+). Follow instructions as shown on page 5 and 6 when
changing welding method.
2.1.6 Connecting torch and extension cable
Connection to the Protig 410 unit is shown on page 5 (air-cooled torch) and on page 6 (liquid-
cooled torch).
Tighten connector of torch carefully in order to avoid heating, contact disturbances and
mechanical damage of connector as well as gas leakage to inside of connector.
NOTE! Check by connection of water and gas hoses that there is no dirt, metal powder or other
waste. Waste might cause blockage of water circulation, throughburning of torch, or stopping or
breaking of pump (Procool 10, Procool 30).
Connect water hoses of torch and interconnecting cable as shown in figure on page 6. (These
are fixed to tube frame). Fix water hoses (torch - interconnecting cable - Procool) in such a way
that those having red code always are connected to corresponding red counter connectors
and the blue ones respectively to blue counter connectors.
8
Pr
oT
ig 410 H
yundai / © Kemppi O
y / 1135