Kemppi Protig 410 User Manual
Page 18
EN
3.1.12 Controls for MMA welding
1
2
1.
Select the MMA welding.
2.
Adjust with the +/- keys current needed.
Set value can be seen in display P23 on no-load. At welding the display shows welding
current. When the light H26 for remote control is lighted, you can control welding current
from remote control unit R10.
Don`t forget to change polarity of welding current by changing connection of cables as
shown in figures on page 5 or 6.
3.2
CONTROL PANEL TX 6271266
H26 P23
S29
S28
S21 S22
S24 S51 P51 S27
S23
P25
Read following paragraphs in operation instructions for panel TL:
Selection of MMA/TIG welding (S21)
Selection of TIG ignition method (S22)
Selection of operation mode of torch switch (S23)
Operation of control unit (S27), (S28)
Display for post gas time (P25)
Local and remote control of welding current (H26)
Welding current display (P23)
Controls for MMA welding
16
Pr
oT
ig 410 H
yundai / © Kemppi O
y / 1135