Vertex Standard eVerge EVX-531 - Manual (Page 33)

EVX-530 S
EriES
O
pErating
M
anual
31
s
pEEd
d
Ial
Your Vertex Standard dealer may have pre-pro-
grammed Auto-Dial telephone number memories into
your radio.
To dial a number:
In the EVX-531/-534, press, (or press and hold), the
assigned PF key, then press the SIDE-1/SIDE-2 but-
tons (or [A]/[B] keys) to select the Auto-Dial memory
number you wish to dial. Press the PTT switch to
send a pre-defined DTMF tone. The DTMF tones
sent during the dialing sequence will be heard in the
speaker.
In the EVX-539, press, (or press and hold), the as-
signed PF key, then press the keypad ([0] - [9] key)
corresponding to the Auto-Dial memory number you
wish to dial. The EVX-539 send a pre-defined DTMF
tone, and the DTMF tones sent during the dialing se-
quence will be heard in the speaker.
dtmF c
odE
s
Et (EVx-539)
 Press, (or press and hold), the assigned PF key to
start entering the DTMF dialing sequence.
 Enter the DTMF digit directly from the keypad
([0] - [9] key).
 After entering all DTMF digits, press the PTT
switch to transmit the DTMF code.
c
all (EVx-531)
Press, (or press and hold), the assigned PF key to
send a 2-tone/5-tone sequential tone.
c
all (EVx-534 & EVx-539)
The Call feature of the EVX-534/-539 is different by
the operating system and operating mode.
When using the DTMF Paging System
(EVx-539)
This feature, if enabled, allows the user to send any
3-digit Page Call code, used to call other similarly-
equipped stations. Press, (or press and hold), the as-
signed PF key, followed by the three digits represent-
ing the Page Call code of the station you wish to call.
Three tones will be heard after the last key is pressed
(the new code will now be transmitted).
The receiver squelch of the other station will be
opened, and you can begin communication.
When using the 2-tone/5-tone Signaling System
This feature, if enabled, Press, (or press and hold), the
assigned PF key to send a 2-tone/5-tone sequential
tone.
a
dVancEd
o
pEratIon