La Crosse Technology WS-9119U - Manual (Page 9)

9
Time alarm icon
TIME ALARM SETTING
The alarm time can be set when pressing the ALM TIME key.
1.
Press and hold the ALM TIME key until the “ALARM” digits are shown and flash. Use the MAX/+ or MIN/- key to
set the alarm ON/OFF. The time alarm icon “ “ is shown to indicate that the alarm is ON.
2. Press the SET key to enter the alarm time set mode. The hour digit start flashing
3. Press the MAX/+ or MIN/- key to set the hour.
4. Press the SET key to switch to the minutes. The minute digits start flashing.
5. Use the MAX/+ or MIN/- key to set the alarm minutes.
6. Confirm with the SET key and exit the Time Alarm setting or wait for automatic timeout.
Note: The maximum alarm ring duration is 2 minutes.
To stop the alarm, press any key during alarm ringing.
WEATHER ALARM SETTING
The intelligent weather station can be set to alert when a specific weather condition is reach.
The following Weather Alarm settings can be changed when pressing and holding the ALM DATA key for
approximately 4 seconds:
•
LOW indoor temperature alarm
• HIGH indoor temperature alarm
• LOW outdoor temperature alarm
• HIGH outdoor temperature alarm
•
LOW indoor humidity alarm
• HIGH indoor humidity alarm
• LOW outdoor humidity alarm
• HIGH outdoor humidity alarm
• LOW air pressure alarm
Default alarm values:
Temperature Low 32ºF
High
86ºF
Humidity Low 20%
High 90%
Air pressure Low 29.52
inHg
LOW INDOOR TEMPERATURE ALARM SETTING
Note:
After pressing the ALM DATA key within the LOW indoor temperature alarm setting there are the following individual
sub-settings.
To set the LOW indoor temperature alarm (default OFF):
I.
Buzzer ON/OFF (alarm sounding):
1. Press the ALM STOP key to set buzzer ON/OFF. The “ “ icon will appear if the buzzer alarm is ON. No
acoustic alarm signal will be heard when the weather alarm is trigged if buzzer is set OFF.
II. Set the alarm ON/OFF:
1.
Press the MAX/+ or MIN/- key to activate the alarm ON/OFF.
III. Set the alarm value (default 32ºF)
1.
Press the SET key to enter the alarm value setting (alarm value flashing)
Alarm time