Marantz UD7006 - Manual (Page 14)

10
ENGLISH
Basic connections
FRONT
SUBWOOFER
R
L
R
L
R
L
SURROUND
SURROUND BACK
CENTER
AUDIO
VIDEO
VIDEO IN
Y
P B
P R
COMPONENT
VIDEO IN
R R
L L
R R
L L
R R
L L
R
L
R
L
AV Receiver
In the case of a 5.1-channel connection, you do not need to connect the SBR/SBL terminals.
Set “Speaker Setting“ – ”Configuration” to “5.1ch“ (
vpage 42).
Important information
• Connect this unit as follows before using. Make connections according to the equipment you are
connecting.
• Some settings of this unit may be necessary depending on the connection method. Check each
connection item for more information.
• Select the cables (sold separately) according to the components being connected.
NOTE
• Do not plug in the power cord until all connections have been completed.
• When making connections, also refer to the operating instructions of the other components being
connected.
• Be sure to connect the left and right channels properly (left with left, right with right).
• Do not bundle power cords together with connection cables. Doing so can result in noise.
Connecting an AV receiver
For connecting using an HDMI cable, see “Connect” ( vpage 5). This section describes the connections
not using an HDMI cable.
Connecting to an AV receiver with an analog multi-channel audio
input terminal
• This connection is recommended when the specifications of an AV Receiver connected to the unit are
as follows:
• Not supporting HDMI input
• Not supporting digital audio(coaxial) input
• This connection enables decoding a playback signal of HD Audio on a Blu-ray Disc to an analog multi-
channel signals with this unit and playing back of all channels on the Disc, including surround back
channel signals, with high fidelity.
Cables used for connections
Audio and Video cable
Audio and Video
cable
R
L
R
L (White)
(Red)
(Yellow)
Audio cable
Audio cable
(center,subwoofer)
(Sold separately)
Video cable
Component video
cable
(Sold separately) (Green)
(Blue)
(Red)