Marantz SA11S3N - Manual (Page 34)

27
ENGLISH
[USB/iPod]
Problem Cause Corrective action Page
“USB OC” appears
on the display.
• The voltage able to be
supplied from this unit via
the USB memory device
has been exceeded.
• The USB memory device
is not supported. Please
use a USB memory
device with an operating
current that is less than
1 A.
• To clear the “USB OC”,
remove the USB memory
device and turn this unit
off and on.
–
–
“Empty” appears on
the display.
• No file able to be played on
this unit exists.
• Check supported formats. 18
The sound of the USB
memory device being
connected is not
heard.
• The amplifier and speakers
are not connected properly.
• Connect the cables
correctly. (See the
instruction manual for the
amplifier.)
–
• The amplifier power is not
ON.
• Turn the amplifier power
ON. (See the instruction
manual for the amplifier.)
–
• The amplifier’s function
or selector switch is not
set to “CD” or “AUX” or
such (to whatever you have
connected this unit to).
• Switch the amplifier’s
function or selector
switch to “CD” or “AUX”
or such (to whatever you
have connected this unit
to). (See the instruction
manual for the amplifier.)
–
• The amplifier’s volume
control is set at the
minimum level.
• Adjust the amplifier
volume. (See the
instruction manual for the
amplifier.)
–
Problem Cause Corrective action Page
The sound of the iPod
being connected is
not heard.
• The amplifier and speakers
are not connected
correctly.
• Connect the cables
correctly. (See the
instruction manual for the
amplifier.)
10
• The amplifier power is not
ON.
• Turn ON the power to
the amplifier. (See the
instruction manual for the
amplifier.)
–
• The amplifier’s function
or selector switch is not
set to “CD” or “AUX” or
such (to whatever you have
connected this unit to).
• Switch the amplifier’s
function or selector
switch to “CD” or “AUX”
or such (to whatever you
have connected this unit
to). (See the instruction
manual for the amplifier.)
–
• The amplifier’s volume
control is set at the
minimum level.
• Adjust the amplifier
volume. (See the
instruction manual for the
amplifier.)
–
Reading of USB
memory device takes
time.
• When connecting a high-
capacity USB memory
device, it will take time
to read depending on its
capacity. Several minutes
may be required for reading
when using a high-capacity
device.
• Wait until reading is
completed.
–
Power fails to switch
on when the remote
controller’s X
CD is
pressed.
• The unit’s power switch
is off.
• Press the unit’s power
operation switch.
• Or, press the unit’s
power operation switch,
then press the remote
controller’s X
CD .
12
12
1.SA-11S3N_ENG_Final_0525.indd 27 2012/05/25 17:14:09