Marantz SA-17S1N - Manual (Page 25)

ENGLISH
23
• The disc fails to rotate.
1. Is the mains lead plugged in properly?
2. Is the POWER switch ON?
3. Is the disc placed in the correct position on the disc tray?
4. Is the disc placed properly with the label side facing up?
5. Is the disc dirty?
6. Is the disc scratched?
7. Is the disc warped?
• The disc is rotating but no sound is heard.
1. Are the amplifier and speakers connected properly?
2. Is the amplifier switch ON?
3. Is the amplifier’s volume control set at the minimum level?
4. Is the amplifier’s selector switch set to the correct input
(“CD” or “AUX”, whichever corresponds to the input jacks
the SACD player is connected to)?
• The disc stops in mid-operation.
The sound drops out or noise is heard.
1. Is the disc dirty?
2. Is the disc scratched?
3. Is the disc warped?
* In the case of a CD-R or CD-RW disc, this problem may
occur when the conditions under which its data was
originally written were substandard or when the quality of
the disc itself is poor.
• Remote control operation is not possible.
1. Is the remote control unit’s transmitter pointed correctly at
the remote sensor on the front of the SACD player?
Or is there an obstruction between the transmitter and the
remote sensor?
2. Are the batteries in the remote control unit exhausted?
3. Is there another strong light (from a window, etc.) striking
the SACD player’s remote sensor?
TROUBLE SHOOTING
• A Super Audio CD cannot be played.
1. Is the disc scratched, dirty or warped?
2. Is the amplifier’s input selector set to digital?
* Digital audio signal will not be output when a Super Audio
CD is played.
• Some channels are not played (Super Audio CD Multi-
Channel)
1. Confirm the number of channels in the disc. (See page 17)
• A CD-R/CD-RW disc cannot be played.
1. Is the disc placed upside down?
2. Is the disc contains properly written TOC?
3. Is the recorded information in an audio (CD-DA) format?
If you think a malfunction has occurred, first check the points listed below. The problem is likely to have been caused by a simple
operational error or a connection problem. If the problem cannot be corrected even after carrying out the following checks,
consult your dealer or nearest Marantz sales office or service counter.