Maytag MDG9800AWQ Installation - Manual (Page 8)

INSTALLATION
Parts and literature are packaged inside of dryer drum.
To Install…
1.
Move dryer to an appropriate location for installation. Consider installing the
dryer before the washer in side-by-side installations, to allow access to gas,
electrical and exhaust connections.
Lay two of the carton corner posts on the floor. Tip the dr yer forward on its
front so it will lay across both corner posts.
2.
Remove the crate wires holding the crate base to the base frame. This can
be done with a screwdriver.
3.
Loosen the leveling locking nuts and install the vinyl feet.
4.
Set the dryer back in an upright position.
5.
R ev i ew the exhaust section on the reverse side before installing the
exhaust system. Install the ductwo rk from the dryer to the exhaust hood.
The crimped end of the duct sections must point away from the drye r.
D O N OT use sheet metal screws when assembling ducting. These joints
should be taped. N ever use plastic flex i ble exhaust material.
Tip for tight installations: install a section of exhaust system to the dryer
before moving the dryer in place. Use duct tape to secure this section to
the dryer but do not cover louvers in dryer cabinet.
• Improper connection of the equipment-grounding conductor can result in a risk of electrical
shock. Check with a qualified electrician or serviceman if you are in doubt as to whether
the appliance is properly grounded. Do not modify the plug provided with the appliance –
if it will not fit the outlet, have a proper outlet installed by a qualified electrician.
• To prevent unnecessary risk of fire, electrical shock or personal injury, all wiring and
grounding must be done in accordance with the National Electrical Code ANSI/NFPA, No.
70-Latest Revision (for U.S.) or the Canadian Electrical code CSA C22.1 – Latest Revision and local
codes and ordinances. It is the personal responsibility and obligation of the appliance owner to provide
adequate electrical services for this appliance.
• All gas installations must be done in accordance with the National Fuel Gas Code ANSI/Z2231 – Latest
Revision (for the United States) or the CAN/CGA – B149 Installation Codes – Latest Revision (for
Canada) and local codes and ordinances.