MBM Corporation 352S - Manual (Page 24)

Operator's Manual multipli 35 Air Feeder S 32
Mathias Bäuerle GmbH 27
Adjusting the front paper stop:
The position of the front paper stop (1) can be
adjusted in a horizontal and vertical direction.
Adjusting the horizontal position:
The horizontal position of the front paper stop deter-
mines the suction point on the paper and in turn de-
pends on the position of the suction segment in the
suction drum.
1
2
4
5
3
6
The inclination of the suction segment
must be set correctly before making the
horizontal adjustment (see page 23/24).
When the suction segment is adjusted,
the horizontal position must also be
changed accordingly.
• Turn the handwheel until the openings of the suction drum (2) are exactly above
the openings of the suction segment (3).
• Adjust the horizontal position of the front paper stop in such a way that it forms a
vertical line (4) with the leading edge of the suction openings. To achieve this,
turn the knurled screw (5) counter-clockwise or clockwise.
Adjusting the vertical position:
The respective paper thickness is set by adjusting the vertical position of the front
paper stop. Proceed as follows:
• Place a stack of about 50 sheets on the feed table.
• Switch on the pump.
• Start the machine (switch position I).
!
Exercise caution in the vicinity of rotating shafts and rollers!
Hair, loose garments and jewellery may get caught!
SERIOUS INJURY MAY RESULT!
• By turning the knurled screw (6), adjust the vertical position of the paper stop in
such a way that only one sheet is pulled off the stack.
• Switch off the machine (switch position 0).