MBM Corporation 352S - Manual (Page 25)

Operator's Manual multipli 35 Air Feeder S 32
28 Mathias Bäuerle GmbH
Setting the Sheet
Gap The sheet gap can be changed by means of
a set screw (1).
This adjustment changes the speed of the
suction drum, i.e. the gap between sheets
is the result of the speed difference be-
tween feed drum and fold rollers.
• Small gap between sheets:
Turn the screw (1) all the way clock-
wise by means of a 2-mm Allen key.
For all parallel folds with the exception of letter fold in fold plate 1 and 2.
• Large gap between sheets:
Turn the set screw (1) all the way counter-clockwise by means of a 2-mm Allen
key. To be used when the sheet length in the first fold plate is larger than half
the length of the unfolded sheet (example: letter fold in fold plates 1 and 2).
1
The feed speed has no influence on the speed of the fold rollers.
Folding speed is set separately.
Positioning the
Paper Stack • Fan the paper stack to avoid double sheets.
• Place the stack on the feed table (2).
• Position the rear paper stop (3).
It prevents the paper from sliding
off towards the rear.
2
3