MBM Corporation 352S - Manual (Page 43)

If it is not installed, proceed as follows:
• Loosen both Allen screws (6) of the gear - they are secured
against loss. The gear can now be split into two sections.
• Connect the sections of the gear on the lower delivery shaft
(7). Slightly tighten both Allen screws.
• Connect the bridge.
Make sure that the cutouts of the
bridge are properly seated on the
pins (8) and the cross-bar (9).
• Check that the drive gear meshes with the gear of the bridge.
• Tighten both Allen screws (6).
• Connect delivery A 35 to the cross-bar (9).
• Adjust the height of the foot by turning the setting screws (10).
Operator's Manual multipli 35 Fanned Delivery
46 Mathias Bäuerle GmbH
14. FANNED DELIVERY A 35
This type of delivery (order-no. 5.500.265) is equipped with an extended transport
belt. This feature increases the capacity so there is more time between removing paper.
The continuously adjustable drive permits a precise setting
of the fanned delivery by means of a potentiometer.
Components and operating elements:
1 Transport belt
2 Potentiometer for belt speed
3 Stacker plate
A transfer bridge (4) must be attached to the delivery
end of the fold unit when working with a delivery A 35.
Description
1
2
3
10
Installation When the bridge is used for the first time, check
whether there is a drive gear (5) on the lower
delivery shaft.
4
6
6
7
8
9
5
Drive for standard delivery
7