Dukane Dual Servo Spin Welder 403570-01 - Manual (Page 15)

Dukane Manual Part No. 403-570-01 Page 
Section 2 - Safety Considerations
IMPORTANT
N eve r o p e r ate t h e D u a l
Ser vo Spin Welder with
the protective sheet metal
removed . This is an unsafe
practice and can result in injury .
IMPORTANT
Always wear a face
shield when operating the
welder .

CAUTION
Welded par ts may be hot .
Health and Safety Tips
Please observe these health and safety recommendations
for safe, efficient, and injury-free operation of your
welder. In this manual, the term
welder
and/or
dual servo
spin welder both refer to the Dual Servo Spin Welder.
Proper Installation - Do not operate the Dual Servo
Spin Welder until after the electrical system is properly
installed.
No Unauthorized Modifications - Do not modify your
Dual Servo Spin Welder in any way unless authorized
to do so by Dukane Corporation. Unauthorized
modifications may cause injury to the operator and/
or equipment damage. In addition, unauthorized
modifications will void the equipment warranty.
Keep the Sheet Metal Intact - Do not remove any
of the protective sheet metal enclosing the motor or
controls. The servo motors and drives have exposed
electrical terminals which could cause injury or death
if touched.
Grounded Electrical Power - Operate this equipment
only with a properly grounded electrical connection.
Refer to the NEMA Type 6–20R wiring diagram in
Figure 2–1 and receptacle photo in Figure 3–5. If
there is any question about the grounding of your AC
power, have it checked by a qualified electrician.
Comply with Regulations - You may be required to
add accessories to bring the system into compliance
with applicable OSHA (Occupational Safety and Health
Administration) regulations for machine guarding and
noise exposure.
Operate Safely – Keep your hands and body away
from the tool head during operation. Always wear
a face shield when operating the spin welder. Be
extremely careful not to let long sleeves, necklaces
or long hair become entangled in the spin welder
during operation. Do not operate the welder if under
the influence of alcohol or drugs. Read the warning
labels on prescriptions to determine if your judgement
or reflexes are impaired while taking drugs. If there is
any doubt, do not operate the machine.