Notice, Installation – Montigo H34VO User Manual

Page 13

Advertising
background image

H-Series VO Outdoor Gas Fireplace

Page 13

XG0150 - 070714

Installation

Installing the Log set:
The H42VO* is supplied with a seven ceramic fibre log logset. Unpack

the logs and handle them very carefully.

Top

Right Log

Top Right

Log

Align Pins

Align Pins

Top

Left Log

Top Left

Log

Notch in Log

Pilot Assembl y

Fireplace Base

Rear / Bottom Log

Notch in Log

Figure 10b. Placing Bottom Right / Left Logs.
Step 3. Place the bottom Right and Left logs as shown in figure10b.

Figure 10c. Top Left / Right Log.

Step 5. Place the Centre Front log , Figure 10d below, as shown using

the notch cast in the Bottom Rear log as shown in figure 10c above.

Right Fr ont

Log

Groove

in Log

Rest Log

Center Front Log

Centerline of Fireplace

Align

Bottom Left Log

Air Inlets

Align

Bottom Right Log

Fireplace Base

Place Embers in this ar ea

Step 4. Place the Top Right log as shown in figure 10c. using the (4)

four alignment pins protruding from the top of the Right and Left Bottom

Logs, as shown in figure 10c. With these pins align the Top Right and

Left logs using the predetermined alignment holes cast into the underside

of the logs, as shown above, figure 10d.

Step 2. Place the bottom Rear log as shown in figure 10a.

Figure 10a. Placing Bottom Rear Log.

Step 1. Remove the glass door as described in the previous Instructions.

Figure 10d. Placing Centre Front Log.

Step 7. Place the Right Centre log as shown in figure 10e.

Step 8. Place the Right Center log as shown using the notch in the Top

Right log as a guide, figure 10f.

Figure 10e. Placing Right Center Log.

Figure 10f. Placing Embers.
Step 9. Place the Embers as shown in figure 10f.
Arrange the ember chips on top of the burner tray. Care should be taken

when placing the embers, as blocked burner ports may cause an incorrect

flame pattern, carbon deposits and delayed ignition. Also, the embers

must never be placed in a way that obstructs any of the air inlet ports,

located at the rear of the burner, as shown in figure 10b.

If logs are not placed properly, excessive sooting will result.

NOTICE

Advertising
This manual is related to the following products: