1 input addresses, 2 6.5 examples, Input – Nevion AES-VMUX User Manual

Page 17: Output

Advertising
background image

Configuration

17

AES-VMUX/-SFP User Manual Rev. G

Table 6.2 Start address,

DIP switch settings

DIP SW1 1,2,3,4 or 5,6,7,8 Start address
off,off,off,off

1

off,off,off,on

5

off,off,on ,off

9

off,off,on ,on

13

off,on ,off,off

17

off,on ,off,on

21

off,on ,on ,off

25

off,on ,on ,on

29

on ,off,off,off

33

on ,off,off,on

37

on ,off,on ,off

41

on ,off,on ,on

45

on ,on ,off,off

49

on ,on ,off,on

53

on ,on ,on ,off

57

on ,on ,on ,on

61

6.3.1 Input addresses

The input address switches always set where the AES input signals are multiplexed.

The start timeslot used is set with DIP SW1 5-8 according the above table. The address start points

hop over 4 addresses because the AES ports are always inputs or outputs in blocks of four. The 16

combinations with 4 dip switches cover the range of addresses in the multiplex (16 timeslots x 4 =

64). The other input ports are placed consecutively in the multiplex after the start address.

The audio of these physical input ports will be available in the multiplex for all the AES-VMUX

cards in the chain, unless they are overwritten by inputs on other cards that have overlapping

multiplex addressing.

6.3.2 Output addresses

The AES output signal routing may be set by the DIP switches in DIP mode, or with the Multicon

GYDA system controller.
The signal routed to the first AES output port comes from the timeslot set with DIP SW1 1-4 if the

DIP config mode switch is on/up.

The other physical output ports have signals consecutively in the multiplex after this address.

The output port addressing may be individually controlled by the Multicon system controller if

the DIP config mode switch is off/down.

Advertising
This manual is related to the following products: