Nevion AES-VMUX - Manual (Page 23)

Configuration 23
AES-VMUX/-SFP User Manual Rev. G
6.6 SDTI input control
If an optical is present on the module the input selector may be manually set to one of the inputs
or allowed to switch automatically.
If in DIP configuration mode:-
6.6.1 SW2.4 Manual/Auto
• On: Manual, input is fixed. SW2.5 setting is used
• Off: Auto, input will search for a Network SDTI audio signal. SW2.5 is ignored
6.6.2 SW2.5 Optical/Electrical
• On: Optical input is used
• Off: Electrical input is used
6.7 DIP configuration mode
The AES output port routing and the SDTI input switch control may be controlled by the system
controller and stored in the module. The AES input routing and the AES port directions parame-
ters are always controlled with the DIP switches.
6.7.1 SW2.8 DIP config mode switch.
• On: The card will be configured with the DIP switches. The module will not accept com-
mands from the system controller but may be monitored.
• Off: The module will be configured with the internally stored configuration and the AES
output routing and SDTI input may be controlled with FLP4 commands as listed in chap-
ter 6.
As with all Flashlink modules, stored configurations in the Multicon controller will be applied to
a module that is plugged into a running system, provided that the switch SW2.8 is off and that the
last module present in the system was of the same type. A module with SW2.8 on, plugged into
a running system will overwrite the stored configuration in the Multicon controller with its own
configuration.