Nevion AES-VMUX - Manual (Page 31)

FLP4 commands 31
AES-VMUX/-SFP User Manual Rev. G
9 FLP4 commands
FLP stands for Flashlink Protocol. The current revision of this protocol is 4, hence FLP4. This
specification is available from Nevion support.
The following FLP4 block commands are used in the monitoring and control of the module.
• ablk
• ceq
• lsr
• misc
• mtx
• pin
• pwr
• vmon
FLP4 block numbering is 0 based while the display on the webpage and numbering of the physical
connections is 1 based.
9.1 ablk
The ablk blocks list the AES port direction and signal sampling frequency.
Inputs report AES input signal presence.
Outputs report signal presence on the routed timeslot.
9.2 ceq
The cable equaliser block reports signal presence on the electrical input.
9.3 misc
The misc block has several keywords reporting the following:-
• the programming state of the module where ’fin’ indicates a successful programming.
• ovr is the Card Mode where configuratiuon is not allowed form GYDA.
• the locating state where the front LEDs flash. The keyword ’locating’ is followed by the
number of seconds of locating state remaining.