Nevion DWC-HD-DMUX - Manual (Page 30)

DWC-HD-DMUX Rev. F
nevion.com | 30
Block Blk
#
Commands Example Response Control
957cBu, 247cBu], representing the
range [-95.5dBu, 24.5dBu].
uart 0 - tx The embedded data link, selectable
by cho 13. No control possible, the
word tx indicates that this is a
transceiver only.
Uart info reports link status: los (loss
of signal), raw, or the speed of the
embedded link (example:
115200/8/n/1).
6.2.3 Commands intended for debug/lab use only
Block Blk
#
Commands example Response Control
spir - <address> spir 0x0004 Read a single word (or byte) from a
SPI registers to check register status.
Addressing is 16b and most
significant nibble determines which
chip. These are the address ranges:
0x0000
– 0x0fff : audio DAC
0x1000 – 0x1fff : FPGA
0x2000 – 0x2fff : flash
0x3000 – 0x3fff : deserializer
0x4000 – 0x4fff : serializer
0x5000 – 0x5fff : shift register (for
LEDs)
0x6000
– 0x7fff : video DAC
Note: The video DAC is actually
using I2C, but the addresses are
mapped into the SPI address range.
spiw - <address> <data> spiw 0x0004 0x2c With the same address ranges as for
spir above, this command allows
single SPI registers to be modified.
Modifying SPI registers in the flash
area is strongly discouraged!