Nevion AD6464M - Manual (Page 13)

AD6464M / AD128128M Rev. 7
nevion.com | 13
1. Remove the Multicon VX-MOD card from its slot, according to the description earlier
in this manual.
2. Slide the battery out of its socket, and insert the new battery into the socket.
3. Insert the Multicon VX-MOD card into its slot, according to the description earlier in
this manual.
3.5 X-point module
Each VikinX Modular frame must be equipped with at least one X point card, in order to work
as a router.
A maximum of two X point cards can be inserted into the frame, providing router sizes of
either 64x64 stereo audio or 128x128 stereo audio. The X-point cards are inserted according
to the labelling on the rear side of the frame.
3.5.1 Card insertion
To insert an X-point card, slide the module along the plastic guide rails into its position. On
both sides of the card tray there is a hole next to each module slot. Use the two handles,
which are located on the front of the module to seat the module.
When the tip of both handles is just next to these holes, start to push the handles
simultaneously inwards the card.