Nevion AD6464M - Manual (Page 16)

AD6464M / AD128128M Rev. 7
nevion.com | 16
Diode Red LED Green LED
TEMP The temperature of the card is
outside its legal range. The temperature of the card is OK.
Note that all alarm ranges are configurable from the system controller.
3.5.4 Service switches and Reset button
There are two slide-switches and one push-button switch on the card, as shown in the figure
below.
Reset button Service switches
Figure 1
The push-button switch is the RESET switch. When this button is pushed and released, the
µController of the X point card resets and restarts its operation with its default settings, or the
settings stored in EEPROM.
The slide switch closest to the front of the X point card (SW2): This switch must always stay
in the right position, as seen from the card front. The switch is for factory use only.
The slide switch furthest from the front of the X point card (SW4): This switch must always be
in the left position, as seen from the card front. The switch is for factory use only.