Niveo Professional NGS16TP User Manual
Page 37
33
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
“mirror” command can enable the mirror function and “no mirror” command can
disable it.
“ip default-gateway 192.168.1.100” will set the IP gateway of the switch to
192.168.1.100, and “no ip default-gateway” will put it to factory default setting
192.168.1.254.
23 prompt command
This command is used to set the prompt word for console.
For example,
(config)# prompt AAA
AAA(config)#
24 qos command
This command is used to enable QoS function of the switch. And “no qos” can be used
to disable it.
The traffic scheduling mode (strict priority - ST or weight round robin - WRR) is
selected in “queue” command. And the weighting of each queue is also set in “queue”
command if WRR is selected.
The other QoS settings on ports are configured in “(config-if)#” mode (go with
“interface ethernet 1/x” command. “x” is the port number.) Please refer to “qos”
command in Section 6.2.4.1 for the details.
25 queue command
This command is used to select traffic scheduling mode (strict priority or weight round
robin). If WRR is selected, weighting of each queue is also set with this command.
Entering “queue ?”, the sub-commands will be shown.
(config)# queue ?
bandwidth Assigns WRR weights to QoS priority queues
mode
Assigns priority queues
queue bandwidth x y z command is used to set the weighting of Normal, Medium, and
High priority queues for WRR operation. (Low priority queue is always weight1). “x” is
the weighting of Normal priority queue. “y” is the weighting of Medium priority
queue. “z” is the weighting of High priority queue. And their valid number is 0~3.
(0:weight1 / 1:weight2 / 2:weight4 / 3:weight8).
queue mode strict/wrr command is used to select the traffic scheduling mode. If
“strict” is selected, the higher priority queue always get bandwidth service first. If
“wrr” is selected, bandwidth is shared between queues with their weighting.
26 radius-server command
This command is used to configure the settings for RADIUS Server. The settings will be