Niveo Professional NGS16TP - Manual (Page 41)

37
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
storm-control bc-rate x command is used to set rate limit for broadcast traffic. “x” is
the limit rate number, and its valid value is 0-7. (0:disable, 1:1Kpps, 2:2Kpps, 3:4Kpps,
4:8Kpps, 5:16Kpps, 6:32Kpps, 7:64Kpps)
storm-control mc-rate x command is used to set rate limit for multicast traffic. “x” is
the limit rate number, and its valid value is 0-7. (0:disable, 1:1Kpps, 2:2Kpps, 3:4Kpps,
4:8Kpps, 5:16Kpps, 6:32Kpps, 7:64Kpps)
storm-control fc-rate x command is used to set rate limit for unicast flooding traffic.
“x” is the limit rate number, and its valid value is 0-7. (0:disable, 1:1Kpps, 2:2Kpps,
3:4Kpps, 4:8Kpps, 5:16Kpps, 6:32Kpps, 7:64Kpps)
32 trunk command
This command is used to enable trunk function of the switch. And no trunk comand
can be used to disable it.
The trunk function for the switch works with LACP protocol. The system priority of
LACP is set by “lacp” command. And the settings on ports is done in “interface”
command.
33 username command
This command is used to set the username and password for administrator and guest.
username admin www xxx yyy zzz command is used to set the username and
password for administrator. “www” is the old username. “xxx” is the old password.
“yyy” is the new username. “zzz” is the new password.
username guest yyy zzz command is used to set the username and password for
guest. “yyy” is the new username. “zzz” is the new password.
Administrator is the user who has the right to do configuration modification. Guest is
the user who has the right to view configuration only.
34 vlan command
This command is used to enter VLAN configuring mode. And the prompt will become
...
(config)# vlan database
(config-vlan)#
The operations for VLAN are configured in VLAN configuring mode. Please refer to
6.2.5 VLAN Configuring Commands section for the details.