Niveo Professional NGS16TP - Manual (Page 54)

50
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
3. history command
This command is used to show the history of entering commands.
4. logout command
This command is used to logout from console interface.
5. quit command
This command is used to quit from console interface. It has the same function as
logout.
6. interface command
This command is used to change to interface port(s) or another interface VLAN groups
for next setup commands.
(config-if)# interface ?
ethernet Ethernet port
vlan
Switch Virtual LAN interface
For example,
“(config)# interface ethernet 1/5” will change the setup interface to Port 5 and all the
following commands will be applied to Port 5.
“(config-if)# interface ethernet 1/6-7” will change the setup interface to Port 6-7 and
all the following commands will be applied to Port 6-7.
If “vlan” sub-command is used, the setup interface will be changed to some VLAN
groups. For example,
“(config-if)# interface vlan 100” will change the setup interface to VLAN 100 and all
following commands will be applied to VLAN 100.
The description of commands in interface configuring mode is put in Section 6.2.4
Interface Configuring Commands. Please refer to the section for the details.
7. ip command
This command is used to set IP address of the switch on this VLAN interface. And only
users in this VLAN can access this switch with the IP address remotely.
(config-if)# ip address ?
dhcp Dynamic host configuration protocol
A.B.C.D IP address
renew Renew IP
release Release IP