Nortec AIRFOG Series User Manual
Page 32
28 | AirFog Installation Manual
The factory default setting for the timer is 2 minutes of off time (cleaning time) after every 8
hours of operation. Using settings that result in an off time of less than 10 seconds are not
recommended. As well, using settings that result in an on time of less than 15 minutes are not
recommended.
Setting the System for Normal Operation
Once the start-up and adjustment, and configuration procedures have been completed the unit
is ready to operate normally. The following steps complete the start-up procedures:
Close and lock all covers including the control panel covers.
Tighten the lock nuts on the primary air and water regulators.
Set the humidistat to the desired level.
The AirFog humidification system is now ready to operate normally.