Nortec AIRFOG Series - Manual (Page 8)

4 | AirFog Installation Manual
Parts
A parts list should be included with the drawings developed by the designer. Not all the
necessary parts are provided by Nortec. The following parts are supplied by others:
 Pipe, elbows, pipe hanger and mounting hardware for inside HVAC units, T-joints, pipe size
adapters, Teflon sealing tape and other plumbing supplies from a local plumbing supplier.
Pipe material is either copper, stainless steel or plastic and should be specified on the
designer produced drawings.
 Wire for the electrical connections is 18 gauge standard insulation, which can carry 24 Volts
AC at 1 amp. This wire can be purchased from most electrical suppliers.
 Nails, screws, bolts, threaded rods, anchors, rivets etc. to attach mounting brackets to the
structure. The fasteners used will depend on the material used in the mounting surface.
 Insulation for the cold water pipe feeding the system is required to prevent water vapor from
condensing and dripping on other structures, machines, personnel or materials.
 The Nortec supplied parts should be checked against the designer’s drawings and parts list
to ensure the correct quantity of the correct part numbers are available.