Nortec HP Series - Manual (Page 43)

HP Series Installation Manual | 40
4 Changing Oil:
 Identify your pump from the figures on the adjacent page.
 Remove the oil fill cap and the oil drain plug(s).
 Dispose of spent oil as per local regulations.
 Reinstall the drain plug(s). Torque to 18 lb-ft (hand tight). Do not over tighten.
 Add recommended amount of oil to crankcase. Refer to the chart below for oil capacities.
Ensure that oil reaches the center of sight glass. Do not overfill.
 Reinstall the oil fill cap.
 Press the reset rocker switch inside the pump controller to reset the counter and shutoff the
service indicator.
Table 3: Crankcase Oil Capacity
Pump Model Oil Capacity - Do Not Overfill
Giant P205REIB 9 fl. oz
Giant P208REIB 9 fl. oz
Giant P217REIB 9 fl. oz
Giant P218REIB 9 fl. oz
Giant P219REIB 9 fl. oz
Giant P220REIB 9 fl. oz
Giant P56W 14 fl. oz
Giant P420A 30 fl. oz
- Synthetic 75w-90 grade oil is recommended for all applications (Mobile1 or equivalent).
- Synthetic 15w-50 grade oil can be used as an alternate grade. (Mobile1 or equivalent).
- All labels on pump supersede this manual.
Incorrect oil grades can cause pump damage. Damage resulting from incorrect oil grades is
considered misuse and is not covered by warranty.