Orion System VAV/Zone Controller - Manual (Page 13)

VAV/Zone Controller
Technical Guide
13
Mode
Selection
ENTER
CLEAR ESC
PREV NEXT
DOWN
UP
6 5 4
DEC
7
0
8
1 3 2
9
MINUS
-
STATUS
SETPOINTS
SCHEDULES
CONFIGURATION
ALARMS
ON
OVERRIDES
BALANCE - TEST
ENTER
CLEAR ESC
PREV NEXT
DOWN
UP
6 5 4
DEC
7
0
8
1 3 2
9
MINUS
-
STATUS
SETPOINTS
SCHEDULES
ALARMS
OVERRIDES
System Manager
Figure 11: Operators Interfaces
Programming The Controller
The next step is programming the controller for your specific require-
ments. In order to configure and program the VAV/Zone controller you
must have a central operators interface or a personal computer with the
Prism computer front end software installed. Two different operators
interfaces are available for programming of the VAV/Zone controller.
You may use either the Modular Service Tool or the Modular System
Manager to access the status and setpoints of any VAV/Zone controller
or VAV/CAV controller on the system’s communications loop. See the
Modular Service Tool and System Manager Programming guide for
VAV/Zone controller programming information. If you are going to use
a personal computer and the Prism computer front end software, please
see the Orion Prism Computer Front End Operations Manual. No mat-
ter which operators interface you use, it is recommended that you pro-
ceed with the programming and setup of the controller in the order that
follows:
1. Configure The Controller For Your Application
2. Program The Controller Setpoints.
3. Review Controller Status Screens To Verify System
Operation And Correct Controller Configuration